How to Modify Your Subscriptions
Go to the Login page and click on Manage subscriptions
Enter your email and then enter the code after you receive it
Now you are in the subscription area where you can modify or cancel your subscriptions. You can also change your form of payment and addresses.
Blog posts
-
Using Your Welflos Infuser Water Flosser
Can I use a Weltab for 2 sessions? No. If there is some of the tablet left do not save it for your next use. WELTABs are designed for single use....
Using Your Welflos Infuser Water Flosser
Can I use a Weltab for 2 sessions? No. If there is some of the tablet left do not save it for your next use. WELTABs are designed for single use....
-
WELFLOS M FAQs
My Welflos M pressure control isn't working. Unplug your flosser for 30 seconds. This will reset the memory chip. This is caused by power fluctuations that occur periodically with all...
WELFLOS M FAQs
My Welflos M pressure control isn't working. Unplug your flosser for 30 seconds. This will reset the memory chip. This is caused by power fluctuations that occur periodically with all...
-
WELFLOS T FAQs
What AC voltages does the WELFLOS T travel water flosser operate with? The WELFLOS T is supplied with an AC adapter that operates from 110 to 240 volts AC input...
WELFLOS T FAQs
What AC voltages does the WELFLOS T travel water flosser operate with? The WELFLOS T is supplied with an AC adapter that operates from 110 to 240 volts AC input...
Collapsible content
How do I qualify for Wel Club?
Purchase at least $100 of products each year. Here are the details
How do I modify my Subscriptions?
What is the warranty on Welflos and Weltip?
Welflos has a 2 year warranty and Weltip has a 1 year warranty. Here are more details
How do I replace my Welflos M handle?
Loosen and remove the 2 screws.
Very carefully use a small flat screwdriver and gently pry the connector from the base port. Do not pry from the side with the tube as you may break the barbed input connection.
After the connector is removed very carefully, using a small flat screwdriver, slide the plastic ring away from the connector. This loosens the grip of the tube on the barbed input connection.
Now you need to remove the connector from the existing tube. You can cut the tube to remove the connector.
Now that you have removed the connector slide the tube from the base.
Slide the new handle's tube through the opening in the base. Then slide the plastic ring onto the tube. One side of the ring is slightly recessed. That is the side that slide onto the connector. Carefully slide the tube onto the connector. Carefully slide the plastic ring toward the connector to grip the tube onto the barbed fitting. Now that everything is like the original, attach the connector to the base and secure with the 2 screws.